CAPS for hole closure.

 
 

These caps are used to close holes in gear boxes – gear reduction units – and anywhere it is necessary to leave a hole on the outside of the box. 

There are two types:

  1. The normal type C cap that cannot be used again once removed. 
  2. The CF cap with flange and beaten rim that can be used again after use.
Code nos. Description
TA.035007 Hole closure cap 35 x 7
TA.035008 Hole closure cap 35 x 8
TA.040007 Hole closure cap 40 x 7
TA.047007 Hole closure cap 47 x 7
TA.047008 Hole closure cap 47 x 8
TA.047008.F053 Rimmed hole closure cap 53/47 x 8 
TA.052007 Hole closure cap 52 x 7
TA.052008.F058 Rimmed hole closure cap 58/52 x 8
TA.055007 Hole closure cap 55 x 7
TA.062010 Hole closure cap 62 x 10
TA.072010 Hole closure cap 72 x 10
TA.080010 Hole closure cap 80 x 10
TA.085010 Hole closure cap 85 x 10
TA.090010 Hole closure cap 90 x 10
TA.110010 Hole closure cap 110 x 10
All the caps listed here are available in NBR and the price list has been calculated with the cost of that raw material.

Products with other kinds of mixture will be valued according to the quantity and type of mixture contained.